Buy Fabric Fabric News Control system overview

Control system overview



Control system overview The water-jet loom control system usually uses the CPU as the control center to control the planning, operation, forward rotation, reverse rotation, stop, p…

Control system overview

The water-jet loom control system usually uses the CPU as the control center to control the planning, operation, forward rotation, reverse rotation, stop, positioning braking and various fault detection of the loom (mainly including: warp over-tension , left and right hemming, front and rear waste wire, fixed length, weft wire detection, etc.), after analysis and processing, it is controlled through the actuator.
The PLC control system uses the PLC programmable manipulator as the control center. The aforementioned command signals and detection signals are sent to the input end of the PLC, and the PLC analyzes and processes and issues execution instructions for control.
The electrical block diagram of the water-jet loom is shown in Figure 3-36 and Figure 3-37.



The control system mainly includes loom transmission and braking, loom fault detection, weft detection, logic control, electronic weft storage, electronic let-off, electronic take-up and other parts.
The control system mainly includes loom transmission and braking, loom fault detection, weft detection, logic control, electronic weft storage, electronic let-off, electronic take-up and other parts.



AAA57865ERT34GSD

Extendedreading:https://www.alltextile.cn/product/product-46-497.html
Extendedreading:
Extendedreading:
Extendedreading:
Extendedreading:
Extendedreading:
Extendedreading:
ExtendedReading:
Extendedreading:
Extendedread

This article is from the Internet, does not represent 【www.buyfabric.net】 position, reproduced please specify the source.https://www.buyfabric.net/archives/41361

Author: clsrich

 
TOP
Home
News
Product
Application
Search